BETA MARINE

DescriptionReplacement fresh water pipeFrom heater exchanger lower hose to water elbow to the fresh water pump.   Used on Beta 28, Beta 30, Beta 35, and Beta 38 (2,800 rpm only)NB. Part number &...

DescriptionReplacement   exhaust bend gasket forBeta 70T & 85T Heat Exchanger  &  Keel Cooled  engine seriesBeta 75 & 90 (Naturally Aspirated) Heat Exchanger  &  Keel Cooled engine...

DescriptionRemote mounted coolant overflow tankoverall dimensions:   Height 7.5 €³   /   Depth   4 €³   /     Width   6.5 €³

DescriptionAuxiliary electric (12 volt) fuel pump.   Includes hose barb fittings for 5/16 €³ hose.Additional relay harness available (see below) to power fuel pump with the key switch.

DescriptionReplacement latching mechanism for the recessed instrument panel enclosure boxes.   Includes the latch as well as the catch with double sided tape to attach to the lid.

DescriptionFuel shut off valve typically used to isolate remote mounted fuel filters (ex Racor) when changing the filter element.

DescriptionFuel fitting typically used with remove mounted fuel filters (ex:   Racor)   to route fuel lines.   Designed for 5/16 €³ fuel hose.

DescriptionFuel fitting typically used with remote mounted fuel filters, (ex Racor), to route fuel lines.   Designed for 5/16 €³ fuel hose.

DescriptionFuel fitting adaptor for the Racor remote bulkhead mounted fuel filters.   Fitting includes O-Ring as shown.   This fitting will set up the filter housing to use 1/4 €³ Male NPT fittings...

DescriptionReplacement 16psi - Twin seal pressure cap for the following engines:All engines. ONLY Used on engines when remote header tank is used.Remote header tank would use the 13 PSI cap...

DescriptionRed touch up paint in a 12oz aerosol spray can.   This Beta Marine Red is great for larger areas that need freshening up.Engines June 2008 and later

DescriptionComplete replacement 12v panel forBeta 10, 14, 16, 20 & 25  mini series engine rangeBeta 28, 30, 35, 38 & 45T super 5 series engine rangeNote:  3 meter wire harness included, if...